Changes of Indicators in Fiber and Cotton Seed Quality in Separating Cut Fractions on Cotton Fiber Mass
M.Kulmetov1, T.A.Toyirova2, Sh.S.Mengnarov3, J.T.Xasanov4, H.X.Komilov

1Prof. Kulmetov Mirpolat, Faculty Technology of light industry and design, Tashkent, Institute of Textile and Light Industry, Uzbekistan.
2Prof. Toirova Tursunoy Abdugapirovna, Faculty Technology of light industry and design, Tashkent Institute of Textile and Light Industry, Uzbekistan.
3Assistent Mengnarov Shuxrat Soatovich, Faculty Technology of light industry and design, Tashkent Institute of Textile and Light Industry, Uzbekistan.
4Assistent Xasanov Jo’rabek Toshboy o’g’li, Faculty Technology of light industry and design, Tashkent Institute of Textile and Light Industry, Uzbekistan
5Komilov Husniddin Xayriddin o’g’li, Faculty Technology of light industry and design, Tashkent, Institute of Textile and Light Industry, Uzbekistan.
Manuscript received on February 10, 2020. | Revised Manuscript received on February 20, 2020. | Manuscript published on March 30, 2020. | PP: 1245-1248 | Volume-8 Issue-6, March 2020. | Retrieval Number: F7540038620/2020©BEIESP | DOI: 10.35940/ijrte.F7540.038620

Open Access | Ethics and Policies | Cite | Mendeley
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)

Abstract: This article describes the fourth type of medium-fiber Hampor, currently widely used in the Surkhandarya region, the lengnth is about 160-170 mg, 171-180 mg, 181-190 mg, 191-200 mg, 201-205 mg, 206-210 mg was divided into fractions by mass of fibers, the LKM equipment was cleaned of fine and dirty particles in the laboratory of the ginnery, DL-10 was isolated from the fiber on the ginning equipment, and the physical and mechanical properties of the seeds, the strength of the breakage, the modal mass, the length of the staple mass, the average mass, the ripening, the length and the squared irregularity were determined by the equipment. The optimal option for fiberglass mass fractionation was proposed to obtain high quality products. Keywords: Fiberglass Mass, Fraction, Halazone, Micropyle, Bark, Knot, Refined, Sucrose, Monochrome, Dextrin
Scope of the Article: Quality Assurance Process, Standards, And Systems.