Design and Fabrication of Solar Water Heater with CPC by using Wafers Packet
Manish R. Moroliya1, Nishikant Z. Adkane2, S.M. Pimpalgaonkar3, G.M. Palatkar4

1Mr. Manish R. Moroliya, Assistant Professor in the Department of Mechanical Engineering in Priyadarshini Bhagwati College of Engineering under Rashtrasant Tukdoji Maharaj Nagpur University.
2Mr. Nishikant Z. Adkane, Assistant Professor in the Department of Mechanical Engineering in Priyadarshini Bhagwati College of Engineering under Rashtrasant Tukdoji Maharaj Nagpur University.
3Mr. S.M. Pimpalgaonkar, Assistant Professor in the Department of Mechanical Engineering in Priyadarshini Bhagwati College of Engineering under Rashtrasant Tukdoji Maharaj Nagpur University.
4Mr. Ganesh M. Palatkar, Assistant. Professor in the Department of Mechanical Engineering in Jhulelal Institute of Technology, Nagpur.

Manuscript received on 2 August 2019. | Revised Manuscript received on 7 August 2019. | Manuscript published on 30 September 2019. | PP: 1175-1178 | Volume-8 Issue-3 September 2019 | Retrieval Number: C4284098319/19©BEIESP | DOI: 10.35940/ijrte.C4284.098319
Open Access | Ethics and Policies | Cite | Mendeley | Indexing and Abstracting
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC-BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)

Abstract: The objective of our project is to create a system which can heat water at maximum temperature and give more efficiency than the current system used in the market today for daily water heating purpose and also less costly which is the main factor. So we made a prototype system of less expensive material and another main material such as wafer packet which will absorbs more sunlight. The evacuated collector for natural circulation discharge through single ended water-in-glass evacuated tubes mounted over a diffuse reflector was also taken into consideration. Therefore, the concept of Compound Parabolic Collector (CPC) is used to heat the water and with a small aperture area as compared to other collectors is possible to achieve a maximum water temperature up-to 100°C. The system is of reasonable cost as compared to existing ones. Collector efficiency is nearly 65%, however if all the control about reflecting rays and insulation is used for reducing the heat loss may be efficiency increasable comparably.
Keywords: Compound Parabolic Collector, Wafers Packet, Solar Radiation, Water Heater, Concentration Ratio, Absorber flux.

Scope of the Article:
Water Supply and Drainage