Evaluation of Bio-Fouling Effect in Cooling Tower by Chemical Treatment
Vilas S. Hajare1, Avesahemad S. N. Husainy2, Mandar A. Jadhav3, Sumit G. Bardiya4,
Siddhanath V. Nishandar5

1Vilas S. Hajare, Professor, Sharad Institute of Technology, College of Engineering, Yadrav, India.
2Avesahemad S. N. Husainy, Assistant Professor, Sharad Institute of Technology, College of Engineering, Yadrav, India
3Mandar A. Jadhav, Assistant Professor, Sharad Institute of Technology, College of Engineering, Yadrav, India
4Sumit G. Bardiya, Assistant Professor, Sharad Institute of Technology, College of Engineering, Yadrav, India
5Siddhanath V. Nishandar, Assistant Professor, Annasaheb Dange College of Engineering & Technology, Ashta, India

Manuscript received on 15 August 2019. | Revised Manuscript received on 25 August 2019. | Manuscript published on 30 September 2019. | PP: 60-68 | Volume-8 Issue-3 September 2019 | Retrieval Number: C4182098319/19©BEIESP | DOI: 10.35940/ijrte.C4182.098319
Open Access | Ethics and Policies | Cite | Mendeley | Indexing and Abstracting
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC-BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)

Abstract: The main aim of this work is to check the bio fouling in cooling tower and its effect on power generation. The way to reduce bio fouling is necessary issue within the thermal power station, as it results in reduction of the heat transfer rate and ultimately reduction in the power generation rate of plant. So as to attenuate the energy consumption in process plant equipped with device network. In various branches of chemical industries fouling builds up on heat transfer surfaces is a heat transfer equipment burning extra fuel to compensate for a reduced heat recovery accepting reduction of plant output due to periodic equipment cleaning and recovering the cost of cleaning interventions. Microbiological fouling can cause energy losses and loss of tower efficiency. The pilot plant is very useful in the thermal power plant to test the cooling water and then it is used in the thermal power plant to reduce the losses due to the bio fouling. In large power plant they having pilot plant with PLC system and microprocessor with highly accurate sensors. It will give very accurate and direct digital readings on screen.
Key Words- Cooling Tower, Bio-fouling, Chemical treatment

Scope of the Article: