Development of Design and Substantiation of The Parameters of the Separator for Fibrous Materials
M. T. Khojiev1, A. Juraev2, O. Murodov3, A. Rakhimov4
1Khojiev Mukhsin Todjievich (Gulistan, Uzbekistan) Doctor of Technical Sciences, Professor, Rector of Gulistan State University.
2Juraev Anvar Djuraevich (Tashkent, Uzbekistan) – Doctor of Technical Sciences, Professor, Department of General Technical Disciplines, Tashkent Institute of Textile and Light Industry.
3Murodov Orif Djumaevich (Tashkent, Uzbekistan) PhD, Teacher. Institute of Retraining and Advanced Training of Public Education Workers.
4Rakhimov Akbar Kholmurodovich (Termez, Uzbekistan) Teacher to Termez State University
Manuscript received on 10 March 2019 | Revised Manuscript received on 18 March 2019 | Manuscript published on 30 July 2019 | PP: 5806-5811 | Volume-8 Issue-2, July 2019 | Retrieval Number: B2835078219/19 ©BEIESP | DOI: 10.35940/ijrte.B2835.078219
Open Access | Ethics and Policies | Cite | Mendeley | Indexing and Abstracting
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC-BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Abstract: The article provides an analysis of existing separators for raw cotton. Their disadvantages are described. The design scheme and the principle of operation of the separator with side grids of the air duct with curved conical holes are presented. The results of theoretical studies to determine the strength of Stripping and justification of the system parameters. The results of comparative production tests of the recommended separator design for fibrous materials are presented.
Index Terms: Fibrous Material, Separator, Air, Chamber, Stripping, Brush, Friction Force, Hole, Curvature, Mesh, Vacuum Valve, Quality.
Scope of the Article: Materials Engineering