Static & Dynamic Research of Composite Blade using Condition Monitoring Method
Akshay A. Hake1, Nagesh S. Ronge2, Vijay A. Bhingare3, Avinash K. Parkhe4, Pradnya K. Bhuse5, Sanjay N.6

1Akshay A. Hake, SVERI’s, College of Engineering, Pandharpur (Maharashtra), India.
2Nagesh S. Ronge, SVERI’s, College of Engineering, Pandharpur (Maharashtra), India.
3Vijay A. Bhingare, SVERI’s, College of Engineering, Pandharpur (Maharashtra), India.
4Avinash K. Parkhe, SVERI’s, College of Engineering, Pandharpur (Maharashtra), India.
5Pradnya K. Bhuse, SVERI’s, College of Engineering, Pandharpur (Maharashtra), India.
6Sanjay N, SVERI’s, College of Engineering, Pandharpur (Maharashtra), India.
Manuscript received on 14 October 2019 | Revised Manuscript received on 23 October 2019 | Manuscript Published on 02 November 2019 | PP: 2145-2149 | Volume-8 Issue-2S11 September 2019 | Retrieval Number: B12230982S1119/2019©BEIESP | DOI: 10.35940/ijrte.B1223.0982S1119
Open Access | Editorial and Publishing Policies | Cite | Mendeley | Indexing and Abstracting
© The Authors. Blue Eyes Intelligence Engineering and Sciences Publication (BEIESP). This is an open access article under the CC-BY-NC-ND license (

Abstract: The use of composite materials has been increased in different industries like civil, mechanical, aerospace engineering due to their better properties. The rotating blade plays an important role in engineering structures such as turbine blades, airplane propellers, and helicopter blades. This deals with static analysis of composite blade to estimate the material uncertainty by measuring the deflection. The composite blade is fixed like a cantilever beam. To measure this deflection the Hall Effect Sensor is developed which is non contact device works on magnetic field. If magnet is come in front of sensor it creates magnetic field between them and that change in voltage or field is calibrated in terms of deflection of blade. The same process is carried for all the blades to check their uncertainty present in it. Also, it is deals with the dynamic analysis of blade to check their behavior in the axis under rotating condition for different RPM. The acceleration is considered as performance parameter to check the behavior of blade. Also, the setup is developed for accelerations measurement GY-521 Accelerometer. The accelerometer has kept at free end of blade and accelerations are taken in three directions for each rpm and it is represented in a graphical form. The analysis is carryout for both damaged and undamaged blade. The both studies are carried out using condition monitoring approach to observe their behavior of blade in static & dynamic condition before used in any application.
Keywords: Uncertainty, Hall Effect, Static, Dynamic, GY-521, Arduino, Accelerations.
Scope of the Article: Composite Materials